CANOGA PERKINS 9145EMP Network Interface Device Hardware - Manual (Page 39)

Installation 9145EMP Network Interface Device Hardware User’s Manual
Connecting the Electrical Power
27
3.5.4 Connecting the Fiber Optic and UTP Ethernet Cables
3.5.4.1 Optical Fiber Cable Installation
NOTE: To avoid damaging the fiber end-surface or connector, use extreme care
when installing or removing cables.
Connect the Optical Fiber cables to the SFP modules as follows:
1. Plug in the optical cables with proper Tx to Rx or Rx to Tx orientation.
2. Ensure connector locks in place.
3. Label each cable with the signal direction (TX or RX).
3.5.4.2 UTP Cable Installation
Connect the UTP cables to the RJ45 connectors as follows:
1. Plug the UTP Cable into the RJ45 connector.
2. Be sure the locking tab is properly seated.