CANOGA PERKINS 9145EMP Network Interface Device Hardware - Manual (Page 36)

9145EMP Network Interface Device Hardware User’s Manual Installation
Installing the SFP Modules
24
3.4 Installing the SFP Modules
1. Determine which SFP Module(s) is/are required for the User and Network Ports by refer-
encing the SFP Product Data Sheet.
2. Insert a module into each available port and push firmly to seat module (Figure 3-10).
3. Raise latch to lock module in place.
Figure 3-10 SFP Modules
3.5 Connecting the Electrical Power
NOTE: When power is applied, all LED indicators will light amber.
3.5.1 AC Power
NOTE: Country specific power cords are available locally for installations outside
of North America.
The 9145EMP uses a standard IEC320 AC Power Connector. Plug the AC power cord into the
socket at the rear of the 9145EMP and plug the other end of the AC power cord into a convenient
AC outlet.