CANOGA PERKINS N525 Ethernet Termination Service Unit - Manual (Page 58)

3-40 N525 Ethernet Termination Service Unit
2. To add a destination, type [ a ] and press . To edit an existing destination, type [e]
and press , then follow the prompts to set values for these parameters:
a. IP Address
IP address of the destination
b. Trap/Notification Port
UDP Port number for the destination. Range is 1 to 65535, typically set to 162
c. Notification Type
Sets the SNMP version and configuration
V1-Trap: Unacknowledged message with SNMPv1 protocol
V2c-Trap: Unacknowledged message with SNMPv2c protocol
V2c-Inform: Acknowledged message with SNMPv2c protocol
V3-Trap:
Unacknowledged message with SNMPv3 authentication and optional
message encryption
V3-Inform: Acknowledged message with SNMPv3 authentication and optional
message encryption
d. Community Name
Enter the V1-Trap, V2-Trap, or V2c-Inform notification Community Name. Up to 10
characters.
e. SNMPv3- Trap Notification
Pressing cycles through security options when SNMPv3 Trap Notification is
selected.
• Security Name: The name of the N525 user account.
• Security Level: No Auth/No Priv - No user authentication or message
encryption
Auth/No Priv - Authentication by user name, no message
encryption
Auth/Priv - Authentication by user name and message
encryption
f. SNMPv3- Inform Notification
To configure SNMPv3-Inform notification, either type [a] value and press or
----------------------------------EDIT TRAP/NOTIFICATION TYPE-------------------
IP Address : 172.016.002.040
Trap/Notification Port : 162
Notification Type : V1-Trap
1. Community Name : public
Select [1]:
------------------------------------Messages------------------------------------