CANOGA PERKINS 9151 Network Interface Device - Manual (Page 21)

2. At the SNTP Client Configuration screen, type the number for a parameter and press ,
then follow the prompts on the screen.
• 1. SNTP Enable: Enable (yes) or disable (no) synchronized time
• 2. SNTP Server IP Address: Enter the address for the server; 0.0.0.0 indicates no server
• 3. Time Resync Interval in hours: Set how often, in hours, that the 9151 tries to synchronize its
time to the Sntp server; Range is 0 (attempt to synchronize at bootup, only) to 24 (once daily)
• 4. Offset from GMT in hours: Set the difference, in hours, between this 9151 and Greenwich
Mean Time (GMT), which is similar to Coordinated Universal Time (UTC); Range is -12 to 12
• 5. Summertime: Enable (yes) or disable (no) Daylight Saving Time
3. To return to the System menu, press .
To directly set the date and time, follow these steps:
1. From the Main Menu, type 6, "Utilities," and press .
2. At the Utilities menu, type 1 , "Set Date and Time" and press .
3. At the prompt to enter the current date and time, type the current information in
DD-MM-YYYY HH:MM:SS format.
4. To return to the Main Menu, press .
Manage SNMP and Host Access
To set values for basic system parameters, including some parameters used by SNMP, go to the IP
Settings screen and follow these steps:
1. From the System menu type 3 , "IP Settings," and press .
2. At the IP Settings screen, type the number for an item and press , then enter data or press
to cycle through the options and press to select an option.
• 1. Local IP Address: Set the IP address for this 9151
• 2. Subnet Mask: Mask that sets the network ID part of the IP address
• 3. Gateway IP Address: Address of the network node that connects to another network
• 4. Enable BOOTP Mode: Enable or disable BOOTP requests
• 5. Management VLAN Id: Set the number for the VLAN
• 6. Management VLAN Double Tagged: Enable or disable double tagging for the VLAN
• 7. Telnet/SSH Host Verification: Enable or disable checking whether host is listed in host
table; default is disabled, which allows access to all hosts
3. To return to the System menu, press .
The SNMP agent allows access to up to 24 Host IP addresses. Set up and edit the Host information
for the 9151 at the Host Access Table screen. To access the Host Access Table, follow these steps:
1. From the System menu type 4 , "Host Table / SNMP Settings," and press .
9151 Network Interface Device 3-7