CANOGA PERKINS 1502 Domain Management Module - Manual (Page 6)

EdgeAccess Universal Chassis System
Model 1502 Domain Management Module 1-2
Features of the Domain Management Module
The DMM, shown in Figure 2, provides these features and functions:
• Command and control up to eight UCS chassis from a single IP address
• Manage up to 224 chassis-based and 224 remote standalone units for up to 448 modules per
domain
• Manage and configure devices within this chassis through the High-level Data-Link Control
(HDLC) protocol, using the domain, virtual group, chassis, and module hierarchy
• Manage and configure remote devices through SBMC, without affecting bandwidth, using the
domain, virtual group, chassis, and module hierarchy
• Create virtual groups based on module type, customer, location, revision, or service priority
• Upload and distribute new firmware revisions to all modules
• Use 10BASE-T Ethernet access to the DMM that supports Telnet and Simple Network
Management Protocol (SNMP) NMS applications
• Use EIA-232 Serial interface access with the DTE/DCE switch for VT100 Terminal/dial-up
modem that supports SLIP and PPP
• Check, monitor, upgrade, and control software revisions through the DMM module code library
• Manage security through strong passwords, encryption, and authentication protocols
• Synchronize the DMM time to the network and Coordinated Universal Time (UTC), which is
similar to Greenwich Mean Time (GMT), through the Simple Network Time Protocol (SNTP)
Figure 2. The Domain Management Module
The Single In-line Memory Module (SIMM) card provides Flash memory that holds the Module
Code Library and the Event and Traps logs so that the information remains available after power-
down and power-up.