CANOGA PERKINS 1502 Domain Management Module - Manual (Page 28)

EdgeAccess Universal Chassis System
Model 1502 Domain Management Module 3-18
5. To finish setting up SNMPv3-Inform notification, either type a value and press or
press to cycle through the options for these parameters:
• Security Name: Enter the name of the user account at the destination, up to 10 characters
• Engine ID: Enter the SNMP Engine ID at the destination; view it at the destination
configuration; 64 Hex characters.
• Authentication Protocol: Set how to authenticate the notification; can be MD5, SHA, or
None.
• Authentication Password: Enter the password that generates the authentication key for
the message if the authentication protocol is MD5 or SHA; 8 to 15 characters.
• Authentication Key: Shows the key that authenticates the notification for MD5 or SHA
Authentication Protocol; this is generated automatically for the Authentication Password,
but can be changed if the destination uses a different Authentication Key generation
algorithm; 16 Hex characters for MD5 protocol or 20 Hex characters for SHA protocol.
• Privacy Protocol: Set the protocol for encrypting the notification; can be DES
(authentication Protocol must be MD5 or SHA) or None
• Privacy Password: If the privacy protocol is DES, enter the password that generates the
encryption key for the message; 8 to 15 characters
• Privacy Key: Shows the key that encrypts the message for DES Privacy Protocol; this
is generated automatically for the Privacy Password, but can be changed if the destination
uses a different Privacy Key generation algorithm; 16 Hex characters
• Security Level: Can be "No Auth/No Priv," no user authentication or encryption for the
message; "Auth/No Priv," authenticates by user name, but no encryption for the message;
or "Auth/Priv," authenticates by user name and encrypts the message.
• Retries: How many times to try to resend the message if not acknowledged; Range is 0
to 10
• Timeout in Seconds: How long to wait, in seconds, for an acknowledgement before
retrying; Range is 1 to 30
6. To delete a destination, type 2 and press , then at the prompt, highlight the IP
Address for that Host and press . The host table appears again with your changes.
7. To return to the Domain Management Module menu, press .
Manage the Domain
The domain is a group of up to eight linked chassis that are managed as a group through the
DMM. You can view events, including status and alarms, manage firmware for modules in the
domain, and manage logged-in users.