Set up host access – CANOGA PERKINS 1502 Domain Management Module User Manual
Page 25
EdgeAccess Universal Chassis System
Model 1502 Domain Management Module
3-15
4. To delete a user, type
2
, then follow the prompts to select the user name and confirm the
choice; the User Accounts Configuration screen reappears.
5. To return to the Change Security & Passwords menu, press
Set Up Host Access
The SNMP agent allows access to up to 24 Host IP addresses listed in the Host Access Table. Set
up the Host and network information for access to the DMM on the Host Access Table screen.
When a host attempts to access the DMM, the IP address is authenticated against the entries on
the host table, from the most restrictive entry to the least restrictive entry. If a user attempts
SNMP access from a host or network that is not listed in this table, the DMM rejects that host and
generates an authentication trap. To access the Host Table, follow these steps:
1. At the Domain Management Module menu, type
6
, "Host Access Table," and press
The Host Table screen appears.
2. To add a host, type
1
and press
3
and press
then follow the prompts on the Edit Host Access screen to enter values or press
cycle through options for these parameters:
a. IP Address: for the Host
b. IP Mask Size: 0 to 32 (bits) to match the bits from the left of the IP address; only one
entry is allowed with 0 bits of Mask Size
c. Telnet Access: Telnet Only, Telnet and SSH, SSH Only, or None
d. FTP Access: FTP Only, FTP and SFTP, SFTP Only, or None
e. SNMP Access: Read, Write (includes Read), or None
f. SNMP Protocol: V1/V2c, V1/V2c/V3, or V3; sets the type of access allowed from the
specific host or network
g. V1/V2c Read Community, Write Community, and Access Level: set the matches for
community names and permissions level (Supervisor, Operator, or Observer) for requests
from the V1 or V2c host or network
3. To delete a host, type
2
and press
that Host and press
4. To return to the Domain Management Module menu, press