BendixKing KPA 900 System RDR-2000 User Manual
Kpa 900
This manual is related to the following products:
Table of contents
Document Outline
- TITLE
- REVISION HIGHLIGHTS
- TABLE OF CONTENTS
- LIST OF FIGURES
- Figure 2-1 – KPA900 Connector Locations
- Figure 2-2 – KPA900 Installation Program
- Figure 3-1 – KPA900 Main Screen Components
- Figure 3-2 – KPA900 Menu Options
- Figure 3-3 – KPA900 Main Form with ART2000 Unit Type Selected
- Figure 3-4 – KPA900 Main Form with ART2100 Unit Type Selected
- Figure 3-5 – KPA900 Main Form with KRA405B Unit Type Selected
- Figure 3-6 – KPA900 KRA405B Parameter Change Form
- Figure 3-7 – File Load and File Save As Form
- Figure 3-8 – Continue with Save Message Box
- Figure 3-9 – KPA900 Main Form with Comment Editor Selected
- Figure 3-10 – Validate CM2000 Form, Initial Screen
- Figure 3-11 – Validate CM2000 Form, Configuration Screen
- Figure 3-12 – Validate CM2000 Form, Conclusion Screen
- Figure 3-13 – Factory Test Form, Initial Screen
- Figure 3-14 – Factory Test Form, Test in Progress Screen
- Figure 3-15 – ART Stab Calibration Form with Default Values Shown
- SECTION 1 GENERAL INFORMATION
- SECTION 2 INSTALLATION
- SECTION 3 OPERATION
- 3.1 Overview
- 3.2 KPA900 Display versus CM2000 Contents
- 3.3 KPA900 Main Screen Components
- 3.4 Unit Specific Configuration Operation
- 3.5 CM2000 Input/Output Operations
- 3.6 Miscellaneous Operations
- 3.7 Typical Operation of the KPA900
- SECTION 4 UNIT PARAMETER DEFINITIONS
- 4.1 ART2000 and ART2100 Parameters
- 4.1.1 Gyro Source
- 4.1.2 Analog Gyro Type
- 4.1.3 Analog Gyro Compensation
- 4.1.4 Mechanical Scan Limit (ART2100 Only)
- 4.1.5 Connector Position
- 4.1.6 Altitude Source (ART2100 Only)
- 4.1.7 Desired Antenna Sweep
- 4.1.8 Wx Gain (ART2100 Only)
- 4.1.9 Map Gain
- 4.1.10 EFIS Strut Switch
- 4.1.11 ARL (ART2100 Only)
- 4.1.12 Auto Step Scan (ART2100 Only)
- 4.1.13 Sector Scan (ART2100 Only)
- 4.1.14 Auto Tilt (ART2100 Only)
- 4.1.15 Target Alert
- 4.2 KRA405B Parameters
- 4.1 ART2000 and ART2100 Parameters