Storix Software SBAdmin Commands Reference - Manual (Page 39)

Storix System Backup Administrator - 39 - Version 8.2 Commands Reference
-m, --retaindays Number of days to retain a backup before expiring
-n, --retainbackups Number of backups to retain before expiring
-Ry, --rawpp Include raw partitions (Linux) and slices (Solaris) on system
backups
-Rn, --norawpp Don’t include raw partitions (Linux) or slices (Solaris) on system
backups (default)
-s, --sendlab where Send backup label to defined report preference (where is file,
email, or printer name)
-t, --type type Backup type (see description section)
-v, --verbose List all profile details (with –l flag)
-wy, --rewind Rewind tape before starting backup job
-wn, --norewind Do not rewind tape at start of backup (default)
--preprog progam Run program on each client before backup (if Network or TSM
Edition)
--postprog program Run program on each client after backup (if Network or TSM
Edition)
--svpreprog program Run program on server before starting job (or local system if not
Network Edition). Not used for TSM Edition.
--svpostprog program Run program on server after all client backups (or local system if
not Network Edition). Not used for TSM Edition.
--presnapprog program Run program on client before creating snapshots (or local system
if not Network or TSM Edition)
--postsnapprog program Run program on client after creating snapshots (or local system if
not Network or TSM Edition)
Details:
The stprofile command is used to add, remove, change and list backup profiles. It may also
be used to customize a default profile for use with a particular job. In that case, the customized
profile options will be used in place of the default profile only for the specified job (no other
jobs using the default profile will be affected).
If creating a customized profile for a job, specify the –j jobid value, where jobid is the Job ID of
a job that was already configured. In this case, you do not specify a profile name. The profile
type that is currently associated with the backup job will be used. Any options that you do not
change will be taken from the original profile. Those specified will override the values of the
original profile. The original profile, and any other jobs that use the original profile, will be
unaffected when creating a customized job profile.
The –t type flag is required when creating a new profile. See the table below for a list of types
and their description.