Sangean WFR-2D V.1 - Manual (Page 73)

GB
Auxiliary input socket
A 3.5mm Auxiliary Input socket located on the rear of your radio is provided for connecting the
audio signal from an external audio source such as an MP3 or CD player.
Connect a stereo lead from the headphone output of your MP3 or CD player to the Aux In socket
located at the rear of the radio. Typically this lead will have a 3.5mm stereo plug at both ends.
Switch on your radio.
From the home menu press the Aux mode button.
Press 'play' on the connected audio device. If you are using its headphone output for the
connection, set its volume control to a level of somewhere between two-thirds and maximum (the
objective is to get a strong audio signal but without too much distortion). Then adjust the volume
on the radio as required.
Note, if using an iPod as the sound source, you may need to set its output to maximum to get an
adequate audio signal level.
After use, disconnect your player in order to listen to your radio conventionally.
X
Auxiliary input
15:05 26 Jun 2010
Aux in