Sangean WFR-2D V.1 - Manual (Page 15)

GB
Connecting to your computer network- cont.
15. If your network is not found, it may be because the router is configured not to broadcast the
SSID. You should then scroll through the menu and select Manual settings option in order to
enter the network details manually. This is described in ‘Manual Network Configuration’. If your
network name is being broadcast, and it was not found, then try re-scanning (press the Back
button), and if necessary try moving your radio to a location to a location closer to your access
point/ router.
16. When the SSID for the wireless network you wish to connect to appears on the screen, touch
to select. If WiFi Protected Setup (WPS) was indicated, you will see an additional menu at this
point, otherwise proceed to step 17. Choose one of the WPS menu options as required for your
router (WPS may be via push button, or using an identification number). 'Push Button' - the
display prompts you to press the WPS button on your router or access point and touch OK on
screen. The two devices should then connect with the encryption key sent automatically to
the radio.
'PIN' - the display shows an identification number which you must enter into your router using
a web browser (refer to your router's user documentation). Then touch OK on screen on the
radio. The two devices should then connect with the encryption key sent automatically to the
radio.
'Skip WPS' - if you wish to enter the encryption key yourself. If you chose Push Button or PIN
the screen will then show 'Connecting...' and then 'Setup wizard completed'. Touch OK to exit
the setup wizard and then go to paragraph 20 on the next page.
17. If your network is configured without an encryption key, the screen should say 'Connecting...',
and then 'Setup wizard completed'. Touch OK to exit the setup wizard and enter Standby mode.
If this is the case then you have successfully connected your radio to your network, so please
go to paragraph 20 on the next page.
18. If the screen displays 'Network Key:', it is because the network is using one of the encryption
systems: Wired Equivalent Privacy (WEP) or WiFi Protected Access (WPA). You will need to
enter the correct WEP or WPA key into the radio to allow it to communicate with your wireless
network. If you do not have the WEP or WPA key, then you should obtain it from the person
who set up your network. Some wireless routers may come with an encryption key already set
up by the supplier, in which case you should refer to the documentation provided with it. WPA
is used here to also include WPA2.
00:00
Network Wizard
Paul’s network
Manual settings
Setup Wizard
Network key:
I
Q E R T Y U I O P
A S D F G H J K L
Z X C B N M
Setup Wizard
123
W
. V
123 - JONES