Sangean WFR-2D V.1 - Manual (Page 62)

Setting the clock format
The clock display used in standby mode and on the playing mode screens can be set to 12 or 24
hour format. The selected format is then also used when setting the alarms.
Access the main Settings menu. Touch Time Settings and scroll down until the current clock
format is displayed. The current time format will appear in yellow.
Touch Time format to select either 12 or 24 hour format. If the 12 hour clock format is chosen,
the radio will then use the 12 hour clock for the setting of alarms, and will display a 12 hour clock
with an AM or PM indicator when in standby mode.
Manually setting the clock
The WFR-2D radio will normally set its clock automatically to UK time after a connection to the
Internet has been established. Should you need to set the time manually, change the time zone,
or manually switch from winter to summer time (GMT to BST - also known outside the UK as
daylight savings time), then please follow this procedure. Manually setting the clock will cause the
Time Source setting to be set to 'None'.
Access the main Settings menu. Touch Time Settings.
Select Manual Setup to enter the time manually.
Select Time and then use the Up and Down arrows to set the correct time.
Touch the Back button to return to the previous screen.
Settings Menu
Time settings
Alarm settings
Equaliser settings Normal
15:05 26 Jun 2010
Settings
Time settings
Use Daylight Saving Yes
Time Source Internet
Manual Setup
Time format 24h
15:05 26 Jun 2010
Settings
Time Manual Setup
Time
15:05 26 Jun 2010
Settings
Set time
14 : 51
15:05 26 Jun 2010
Settings