Sangean DDR-33+ (V1) User Manual
Page 9
8
GB
Operating your radio
1. Press the On / Standby button to switch on your radio. The display
will show “TUNING” for a few seconds.
When first switched on, the radio will be in DAB mode. After each
use the radio will remember the last mode used and then switch on
in that mode the next time that it is used.
2. If the radio has been used before, the last used station will
be selected.
3. If this is the first time that the radio has been used, then the first
station in the list of stations found during scanning will be played.
The display will show the station name on the display.
4. If no signals are found then “OFF AIR” will be displayed and it may be
necessary to relocate your radio to a position giving better reception.
You should then carry out a scan to find stations as described
on the subject as “Display modes – DAB”.
Your radio has an indicator on the display to indicate the
strength of the DAB radio signal being received.
Note:
When first switched on, the radio will set the volume to a moderately
high level, in case the broadcast is very quiet. After you have set the
volume using the Volume Up or Down buttons, the radio will remember
the setting that you have applied for the next time that it is used.