Sangean DDR-33+ (V1) - Manual (Page 8)

7
Using the radio for the first time
1. Place your radio on a flat surface.
2. Fully extend the telescopic aerial located on the rear of your radio.
Place the telescopic antenna so that it is as vertical as possible
extending either above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of
your radio. Plug the adaptor into a standard mains outlet. The display
will show “SANGEAN” for a few seconds and then the display will
show “SET CLOCK”. During this time the radio is to find
a DAB clock radio stations. After a short time the current
time will appear on the display.
4. If no stations are found, “NO CLOCK” will be displayed. Please press
the On / Standby button to switch on your radio. It may be necessary
to relocate your radio to a position giving better reception.
You should then carry out a scan to find stations as described
on the subject as “Display modes – DAB”. Then please press the
On / Standby button again to switch off your radio. After a short time
the current time will appear on the display to replace “NO CLOCK”.
IMPORTANT:
The mains adaptor is used as the means of connecting the radio to the
mains supply. The mains socket used for the radio must remain
accessible during normal use. In order to disconnect the radio from the
mains completely, the mains adaptor should be removed from the mains
outlet completely.
Characters appearing on the LCD display indicate that the radio is
connected to and powered from the mains supply.