Sangean DDR-33+ (V1) User Manual
Page 38
37
System reset
If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press the On / Standby button to switch on the radio. If necessary
press and release the Mode button to put the radio into DAB or
FM mode.
2. Press and release the Menu button.
3. Press and release the Tuning Up or Down button until “FACTORY”
appears on the display. Press and release the Select button so that
the display shows “RESET” and then press the Select button again.
4. A full reset will be performed. The station list and presets will
be erased. Alarms will be cancelled and snooze and sleep timer
settings will be set to their default values. The display will show
“SANGEAN” and after a few seconds a station scan search will be
performed automatically. The display will show the progress of the
DAB station search, for example “>>>>18”. The number on the right
of the display is the number of stations that have been found.
In case of malfunction due to electrostatic discharge, reset the product
as above to resume normal operation. If you are not able to perform the
reset operation as above, removal and reconnection of the power supply
may be required.