Sangean DDR-33+ (V1) User Manual

Page 31

To return to auto clock set mode

1. Press the On / Standby button to switch on the radio. If necessary

press and release the Mode button to put the radio into DAB mode.

2. Press and release the Menu button to enter the setup menu.

“MANUAL” will appear on the display.

3. Press the Tuning Up or Down button until “CLOCK” appears on

the display. Press and release the Select button.

4. Press the Tuning Up or Down button until “AUTO CLK” appears on

the display. Press and release the Select button.

5. The radio will immediately set its time according to the information

received with the DAB broadcast or in FM mode with RDS stations.

The radio will return to normal radio operation with the time

currently displayed.

Note:

If you select “AUTO CLK” the current time received will be displayed.

If no DAB signal is found, “NO CLOCK” will be displayed.

You should then either position the radio or its aerial so that a signal

can be received, or revert to manual clock mode (see the subject as

“Setting the clock manually”).

If your radio is switched on and in FM mode with RDS stations,

you can follow the above procedure of auto clock except the 2

step.

(“MANUAL” won’t appear on the display if you put the radio into

FM mode.)