Sangean DDR-33+ (V1) User Manual

Page 29

Setting the clock manually

Normally your radio will set its clock automatically using the DAB

radio signal. If no DAB signal is available and you need to set the

time manually, please follow the procedure shown below.

1. Press the On / Standby button to switch on the radio. If necessary

press and release the Mode button to put the radio into DAB or

FM mode.

2. To set the clock time, press the Menu button to enter the

setup menu. “MANUAL” will appear on the display.

3. Press the Tuning Up or Down button until “CLOCK” appears on

the display. Press and release the Select button.

4. Press the Tuning Up or Down button until “MANU CLK” appears on

the display.

5. Press and release the Select button to enter the manual

setting procedure. The hour digits will then flash on the display.

6. Press the Tuning Up or Down buttons to set the desired hour.

7. Press and release the Select button to enter the hour setting.

8. The minute digits will then flash on the display. Press the Tuning Up

or Down buttons to set the desired minute.