Setting the alarm clock - cont – Sangean WFR-29D (R1) User Manual

Page 66

Setting the alarm clock - cont.

0. Rotate the

Tuning Control Rotary until the 'Volume:' option is highlighted on the display and

press the

Tuning Control Rotary if you wish to change it. The radio uses the saved volume

setting for each alarm when it sounds. Set the required volume using the

Tuning Control

Rotary to confirm the setting.

11. In order to store the alarm settings rotate the

Tuning Control Rotary until 'Save' is highlighted.

Press the

Tuning Control Rotary to store the alarm settings. Your radio will show 'Alarm

saved' and will then go back to the list of alarms with the new alarm setting shown in the display.

If you decide not to save the settings, press the

Back button. The display will show 'Save

changes' with a 'YES' or 'NO' option. Rotate the Tuning Control Rotary to choose 'NO' and then

press the

Tuning Control Rotary. 'Alarm not saved' will show on the display. Active alarms are

shown using small alarm indicators at the bottom of the playing displays and on the clock display

when in standby.

Note: If you make a mistake at any point while setting the alarms, use the Back button to go

back to the previous screen.

10,11