Sangean WFR-29D (R1) - Manual (Page 12)

. Once you have connected your radio to the network (and therefore also to the Internet) it will
display the main menu. Press the Tuning Control Rotary to put the radio in Standby mode.
It should then display the time as obtained from the Internet. If the time display is not correct
for any reason, it can easily be adjusted later, see ‘Manually setting the clock’. If you have fol-
lowed the steps on the preceding pages successfully, your radio will have connected to your
router, and then made a connection to the Internet and set its clock. If this is the case, then
you can try listening to radio stations via the Internet.
Note: To save the radio power consumption while your radio is powered with battery, the ra-
dio will turn off fully when put into standby mode. As a result, if you switch off your radio when
your WFR-29D is power supplied with battery, next time when your radio is switched on, the
time on the screen will be reset and show as ‘00:00’. However, as soon as the radio connects
with WiFi, the time will update automatically from the network.