Clock and alarms – Sangean WFR-29D (R1) User Manual

Page 60

Clock and Alarms

Automatically updating the clock

Your radio will normally update the clock automatically when connected to the internet. If you

enter a time setting manually, the radio will calculate a local time offset which is then stored in

memory. Whenever it synchronizes the clock using the internet, including after a power failure,

your radio will then set the clock automatically using this information.

You may wish to use the radio away from the internet, in which case you may specify that the

unit sets its clock from DAB or FM radio broadcasts.

After a power failure the radio will then set its clock the next time that you turn on the radio in

DAB or FM mode. Alternatively you may specify that the time is not automatically updated. In this

case the clock must always be set manually after a power interruption.

1. With your radio switched on, press the

Menu button to access the menu for the current mode.

. Rotate the

Tuning Control Rotary until 'System settings' is highlighted on the display. Press

the

Tuning Control Rotary to enter the system settings menu.

. Rotate the

Tuning Control Rotary until 'Time/Date' is highlighted on the display. Press the

Tuning Control Rotary to enter the time setup.

. Rotate

Tuning Control Rotary until 'Auto update' is highlighted on the display. Press Tuning

Control Rotary to enter the auto-update menu.

. Rotate the

Tuning Control Rotary to choose an update option from 'Update from DAB',

'Update from FM', 'Update from Network' or 'No update' as required. Press the

Tuning Control

Rotary to confirm your choice. The radio will then exit to the previous menu display.

2-5