Belt Drives EVO-12S - Manual (Page 2)

4. Push pivot shaft through by using a blunt drift, as
you follow the shaft through with drift, swing arm will
stay in place. (Fig. 3)
Fig. 3 Push shaft through by using a blunt drift, so that the
swing arm stays intact
5. Install special seal, supplied with kit, and replace
pivot bolt with head on drive side. (Fig. 4)
Fig. 4 Use special seal supplied with kit, countersunk side facing
head of pivot bolt. Replace shaft with bolt on drive side of bike.
Install spacer supplied using stock o-ring, and install castle nut.
6. Install motor plate in place on stock inner primary.
Refer to
alignment procedure. (Fig. 5)
Fig. 5 Install motor plate and check for proper fit
7. Remove stock starter pinion gear and complete starter gear assembly from starter. Bolt starter into back side of
motor plate.
need shimming or not depending on how the pulleys align with each other. Remove pulleys and make any
modifications necessary.
2
8. Install front and rear pulleys and check for proper fit. At this time you should determine if the front pulley will