Cybex SOLUTION X-FIX User Manual

Page 13

INSTALLATION OF THE CAR SEAT WITH CONNECTORS

• Connect the two enclosed X-fi x installation aids (their longer parts pointing

upwards) with the two isofiX anchorage points (i).

• You can now buckle up the child. Please refer to “Buckling Up the Child”.

• For adjustment move the X-fi x lever (v), located on the bottom of the seat.

• Pull the connectors (w) as far out as they will go.

• Rotate the X-fi x connectors by 180° until they point into the direction of the

installation aids.

• Push both of the X-fi x connectors (w) into the installation aids until you hear

them clicking into the isofiX anchorage points (i).

• Make sure that the child seat is connected safely by trying to pull it out.

• The green safety indication (x) must be clearly visible on both sides of the red

release buttons (y).

• With the X-fi x button located on the bottom of the child seat you can now

adjust the position of the seat.

The saftey of your child will be increased using the ISOFIX-

CONNECT system linking the child seat tightly with the vehicle.

your child will still be buckled up using the car‘s 3-point-belt.

Note! The car‘s isofiX anchorage points (i) are two metal rings per seat,

located between the backrest and the seat cushion of your vehicle seat.

If in doubt please refer to your vehicle owner’s manual.

Note! Make sure that the green safety indication (x) of the connectors

is not visible. If necessary, release them by pushing and simultaneously

pulling back the red release button (y). Repeat this procedure with the

other connector.

Note! For additional information please refer to the section “Placing the

Seat in the Car”.