OFNA Racing Jammin X1 RTR - Manual (Page 21)

17
47 ADJUSTING THE ENGINE CONTROL LINKAGES
Approx. 1mm gap
Carburetor is
opening fully
#10300 Alum. Stopper
#10300 Alum Stopper
Approx. 0.5mm
(Neutral) (Throttle High) (Brake)
Idling adjusting Screw
A-80A Alum. Adjuster Nut
2X8mm
Hex Screw
3x3mm
Set Screw
#10300
Alum.
Stopper
Snap On.
USING BRAKE ADJUSTER NUT
Loose
Tighten
More Brake Less Brake
Tightening or loosening
the adjuster nut to
change the brakes.
ASSEMBLY OF THE BRAKE LINKAGE INTO BRAKE LEAVER (Type B)
Fuel Tube
* Use the screw
provided with
your servo .
..........X2 M3x3
Set Screw
Place a 8mm piece of
fuel tube as shown.