Rane SEQ 30S (2003 version) - Manual (Page 5)

Manual-3
Cable Wiring
In agreement with
IEC and AES/ANSI
standards, XLR wiring
convention is pin 2
Positive (hot), pin 3
Negative (cold), and
pin 1 Signal ground (for
unbalanced use). Pin 1
and the connector case
or shell are tied to
chassis ground.
LEFT & RIGHT OUTPUTS
Use either the Balanced XLR or the Unbalanced ¼" TS jacks. Using both types
of Outputs are permissible to drive two devices, such as an amplifier and a re-
corder.
LEFT & RIGHT INPUTS
Choose between the balanced XLR or the balanced/unbalanced ¼" TRS jacks,
but only use one. Inserting a ¼" TS jack will work—however—always use bal-
anced lines especially when connecting cables over 10 feet in length. Consult the
Sound System Interconnection RaneNote located later in this booklet.
INPUTS
RIGHT LEFT
BAL / UNBAL BAL / UNBAL BALANCED BALANCED
WIRING
3-PIN XLR:
PIN 1 = CHASSIS, SHIELD,
PIN 2 = (+), PIN 3 = (–).
¼" PHONE, BALANCED:
TIP = (+), RING = (–),
SLEEVE = CHASSIS, SHIELD.
¼" PHONE, UNBALANCED:
TIP = SIGNAL, RING = GROUND,
SLEEVE = CHASSIS, SHIELD.
MADE IN U.S.A.
RANE CORP.
OUTPUTS SEQ 30S
RIGHT LEFT
UNBALANCED UNBALANCED BALANCED BALANCED
N108
¼
T
Rear Panel Description