Rane SEQ 30S (2003 version) - Manual (Page 4)

Manual-2
POWER switch and LED
Your basic, straightforward power
switch. When the yellow LED is lit, the
SEQ 30S is ready to go.
EQ BYPASS switch
When pressed to BYPASS, the filter
sliders have no effect. Since actual unity
gain depends on varying slider settings,
use the BYPASS switch to determine
the unity gain position of the INPUT
LEVEL control by comparing ACTIVE
and BYPASS volumes.
Filter level slide controls
Each of these sliders control the
output level of both channels of the 30
bandpass filters. Center position is
grounded for guaranteed flat response.
INPUT LEVEL control and
indicators
This controls the overall level. 0 dB
gain is reached at the center detent with
all sliders centered at their 0 dB detents.
Set the INPUT LEVEL to give equal
volumes with the EQ switched to
ACTIVE or BYPASS, after setting the
sliders (see EQ BYPASS switch below).
Apply sufficient signal to the input to
occasionally light the +4 dBu indicator.
Flashing of the OL (overload) LED
during peaks can be avoided by turning
the INPUT LEVEL or boosted Filters
down.
0
+
12
•
6
•
•
•
6
12
12 -12
6 -6
0
31.5 25 40 63 50 100 80 160 125 200
INPUT
+4 OL
LEVEL BYPASS
Front Panel Description
STEREO
EQUALIZER
0
+
12
•
6
•
•
•
6
12
SEQ 30S
12.5k 2k 3.15k 2.5k 5k 4k 8k 6.3k 10k 20k 16k
POWER