Axesstel PST - Manual (Page 104)

AXESSTEL Software User's Guide Contents
max_num_sup_ch
is the maximum number of supplemental channels
you are specifying, 0–7.
Example
set_max_fwd_mux 5 3
Response
Sets the maximum number of supplemental channels for IS-96A
Voice calls to 3.
SET_STATUS_FLAG_MASK
Sets the status mask flag. This command is for Module targets only.
Syntax set_status_flag_mask status_flag_mask
status_flag_mask is a 2-byte value. The individual bit values each
indicate an event or state, as described in the following table.
22 Medium Data Rate (also known as High Speed Data) PPP Packet
Data Service (IS-707A) with rate set 1 forward and reverse. Default
Mux = 9 forward 1 reverse.
23 Medium Data Rate (also known as High Speed Data) PPP Packet
Data Service (IS-707A) with rate set 1 forward and rate set 2 reverse.
Default Mux = 9 forward 2 reverse. This service option is not
supported by MSM3000.
24 Medium Data Rate (also known as High Speed Data) PPP Packet
Data Service (IS-707A) with rate set 2 forward and rate set 1 reverse.
Default Mux = 10 forward 1 reverse. This service option is not support
by MSM3000.
25 Medium Data Rate (also known as High Speed Data) PPP Packet
Data Service (IS-707A) with rate set 2 forward and reverse. Default
Mux = 10 forward 2 reverse.
Code Description
Bit Description
0 Digital service: 0=analog service, 1=digital service
1 New SMS message. This bit will be reset every two minutes until
you power cycle the module, if the new SMS message is not
read. It is cleared to 0 whenever an Extended State Packet
Response is sent.
2 Maintenance request when set to 1; cleared by the unlock_order
message defined by IS-95A
Script Command List
Example set_status_flag_mask 32192
SLEEP
AXESSTEL Proprietary
104