WEATHER GUARD Model 9861-3-01 Cable Reel Holder, Floor Mount, 42-1/2 in x 19-3/4 in x 16-1/4 in - Manual (Page 2)

WARNING
All floor mounting bolts near
the gas tank area should be
installed from the underside
of the vehicle, to guard
against the gas tank being
punctured in the event of a
collision. Do not use
Blind Fastener in this area.
If you have any questions, please give us a call. Call Toll Free 1-800-456-7865
WEATHER GUARD® product are protected by one or more of the following trademarks:
U.S. - 842268, 1661625, 1663369, 2228051, 2362167; Canada - 282725; U.K. - 1400720; N.Z. - 296049; Aus. -761964.
KNAACK MANUFACTURING COMPANY
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, USA 60014
815-459-6020
© 2001 Knaack Manufacturing Company
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
INSTALLATION
INSTRUCTIONS
1. Place the Wire Spool Rack in the
desired position and mark the hole lo-
cations, choosing mounting holes that
line up on top of ribs. If one set of
holes do not line up with top of ribs,
Floor Mounting Spacers should be
used between ribs.
(See Figure 2.)
2. Drill hole locations.
Note: To prevent rust from occur-
ring, touch-up any drilled holes.
3. Fasten the Wire Spool Rack to the
floor.
(See Figure 1.)
NOTE - One extra Blind Fastener and
one extra lock washer have been pro-
vided for use in areas where standard
fasteners can’t be used, such as heat
shields and support channels. Use of
the Blind Fastener requires a 1/2" hole.
CAUTION
To keep debris out of your
eyes when checking the
underside of the vehicle, or
when drilling, always wear
protective eyewear.
Figure 2.
When mounting holes are between ribs
Floor Mounting
Spacer
5/16-18 x 1-1/4"
Hex Hd. Bolt
5/16-18 Nylon
Lock Nut
5/16" Flat Washer
Floor Ribs
5/16" Flat Washer
WARNING
Prior to drilling, so as not to
cut or puncture fuel tanks, fuel
lines, brake lines, electric
wires, etc., check under vehi-
cle for locations.
Black
Oxide
Bolt
Flat
Washer
9/16”
Wrench
Installation
Tool
Blind
Fastener
NOTE: Make sure there is enough
hole depth before installing the
Blind Fastener, as it could damage
the vehicle.
INSTALLATION PROCEDURE
USING BLIND FASTENERS
Place a drop of oil on the black oxide
bolt before assembling as shown on
right. Place the Blind Fastener in the
hole and use a 1/2” or 7/16” wrench to
tighten black hex bolt until the blind
fastener is fully seated. When setting
black hex bolt, it will start out hard.
As the Blind Fastener “bulbs” out it
will get easier, until it bottoms out or
sets. Make sure the Blind Fastener
and Installation Tool do not turn dur-
ing installation.