WEATHER GUARD Model 8931-3 Parts Box Cabinet - Manual (Page 2)

If you have any questions, please give us a call. Call Toll Free 1-800-456-7865
Weather Guard® products are protected by one or more of the following patents or trademarks:
KNAACK MANUFACTURING COMPANY
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, 60014 - 815-459-6020
©1992 Knaack Manufacturing Company
-NOTICE-
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
INSTALLATION PROCEDURE
USING PLUSNUT® BLIND
FASTENERS
CAUTION
Prior to drilling, so as not to
cut or puncture fuel tanks, fuel
lines, brake lines, electric
wires, etc., check under vehi-
cle for locations.
Use 7/16" wrench to tighten black hex
bolt until Plusnut® fastener is fully
seated. When setting black hex bolt, it
will start out hard. As the Plusnut®
“bulbs” out it will get easier, until the
Plusnut® bottoms out or sets. Make
sure the Plusnut® and Plusnut® Tool
do not turn during installation.
INSTALLATION
INSTRUCTIONS
1. Place Rack Assembly in position
and pull lower slide all the way out. Re-
move lower slide (See
Drawer Removal) and mark mount-
ing hole locations.
CAUTION
Prior to drilling, so as not to
cut or puncture fuel tanks,
fuel lines, brake lines, elec-
tric wires, etc., check under
vehicle for locations.
3. Fasten unit in position.
NOTE - A 1/4-20 Plusnut®, Plusnut®
Tool, 1/4-20 x 1-1/4" Black Oxide Bolt
WARNING
All floor mounting bolts near
the gas tank area should be
installed from the underside
of the vehicle, to guard
against the gas tank being
punctured in the event of a
collision. This would mean
not using Plusnuts® in this
area.
2. Remove rack assembly and
drill marks with a 5/16" drill bit. Replace
the rack.
CAUTION
To keep debris out of your eyes
when checking the underside of the
vehicle, or when drilling, always
wear protective eyewear.
U.S. - 842268, 1661625, 1663369; Canada - 282725; U.K. - 1400720; other patents pending.
and 1/4" Lock Washer are provided for
use in areas where standard fasteners
can't be used, such as heat shields
and floor supports. See Plusnut® in-
stallation instructions.
NOTE - If stacking, use four 1/4-20 x
1/2" screws (provided) instead of 1/4-
20 x 1-1/4" bolts. Model 8940 Acces-
sory Mounting Strap Kit is required
if stacking units.
DRAWER REMOVAL (above)
1. Pull drawer all the way open, then
push back to align stop with lance stop.
2. Push lance stop in with screwdriver
as shown, until lance stop clears the
stop on the drawer guide.
3. Repeat on the other side and re-
move drawer.
4. To install drawer, pry out lance stop
(approx. 1/4") and push drawer into
slide until it stops.