WEATHER GUARD Model 8230-3-01 Welded Stack Unit, 30 in x 36 in x 12 in - Manual (Page 2)

-NOTICE-
CAUTION
Prior to drilling, so as not to
cut or puncture fuel tanks,
fuel lines, brake lines, electric
wires, etc., check under vehi-
cle for locations.
NOTE: A Blind Fastener and 1/4"
Lock Washer have been provided for
use in areas where standard
fasteners can't be used, such as heat
shields and support channels. See
Blind Fastener installation
instructions.
CAUTION
To keep debris out of your
eyes when checking the
underside of the vehicle, or
when drilling, always wear
protective eyewear.
CAUTION
Prior to drilling, so as not to
cut or puncture fuel tanks, fuel
lines, brake lines, electric
wires, etc., check under
vehicle for locations.
INSTALLATION INSTRUCTIONS
1. Place Shelf Unit in position in ve-
hicle. Mark through mounting holes in
side panel bottom flange.
2. Remove shelf unit. Drill holes. Re-
place unit and secure.
WARNING
All floor mounting bolts near
the gas tank should be in-
stalled from the underside of
the vehicle, to guard against
the gas tank being punctured
in the event of a collision.
If you have any questions, please give us a call. Call Toll Free 1-800-456-7865
WEATHER GUARD® products are protected by one or more of the following trademarks:
U.S. - 842268, 1661625, 1663369, 2228051, 2362167; Canada - 282725; U.K. - 1400720; N.Z. - 296049; Aus. - 761964;
KNAACK MANUFACTURING COMPANY
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, USA 60014
815-459-6020
©2001 Knaack Manufacturing Company
INSTALLATION PROCEDURE
USING BLIND FASTENERS
3. Two wall Mounting Straps and two
Mounting Angles are provided. The
Mounting Straps can be bent to any
shape and/or used with the Mounting
Angles.The Mounting Straps should
be attached to the upper portion of the
unit in a manner that would minimize
movement of the unit both front to
rear and side to side.
4. Fasten the other end of the strap to
the vehicle wall (brace member).
Repeat on the other end of the
cabinet.
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
Black
Oxide
Bolt
Flat
Washer
9/16”
Wrench
Installation
Tool
Blind
Fastener
Place a drop of oil on the black oxide
bolt before assembling as shown be-
low. Place the Blind Fastener in the
hole and use a 1/2” or 7/16” wrench to
tighten black hex bolt until the blind
fastener is fully seated. When setting
black hex bolt, it will start out hard.
As the Blind Fastener “bulbs” out it
will get easier, until it bottoms out or
sets. Make sure the Blind Fastener
and Installation Tool do not turn during
installation.