US Balance US-PROSPECTOR 150g x 0.01g - Manual (Page 2)

CHANGE WEIGHING MODES
Press the “MODE” button to change weighing modes on your scale. This scale has 6
weighing modes: g, oz, gn, ct, ozt, dwt.
CALIBRATION
With the scale turned on and placed on a stable surface, press and hold the CAL button
till the display shows “100.00” , place a 100g standard weight onto the middle of the
weighing platform. Calibration succeeds, and the scale is ready for normal use now.
PARTS COUNTING FUNCTION
Place a small quantity of the item you want to count on the platform, (please note this
should be a quantity of 10 pcs previously counted out by hand.) After the display shows
the weight of the items, then press the “PCS” button for approx 3 seconds. The “PCS”
function has been set up. Remove the items and the display will show “0” you may now
count out items as long as their total weight does not exceed 150g. Once you are finished
with the PARTS COUNTING FUNCTION, press the “MODE” again to cancel the
“PCS” function.
OPERATING ENVIRONMENT
The optimum operating temperature for the scale is 50-86° F/10-30°C. Rough handling of
the scale will damage the internal sensor; so you must avoid actions such as shaking or
dropping the scale. This is a sensitive piece of electronic equipment and will be affected
by things such as moisture, extreme temperature changes, magnetic fields, careless
handling and misuse.
AUTOMATIC SHUT-OFF
The scale will automatically shut-off after 60 seconds of inactivity this is to help conserve
the battery power. We recommend good quality AAA batteries.
Tested to comply with FCC standards.