US Balance US-FIRE 100g x 0.01g - Manual

US-FIRE - User Manual
Capacity: 100g x 0.01g - Weighing modes: g, oz, gn, dwt, ozt, ct
Thank you for purchasing US-FIRE digital scale. Please read all operation
instructions carefully before use.
Scales are precision instruments and should always be handled with proper
care. To ensure years of reliable service, keep these simple tips in mind:
 Do not exceed the scales maximum capacity. Overloading your scale can
permanently damage it!
 Avoid exposure to extreme heat or cold. Scales perform best at normal room
temperature. If temperatures have changed dramatically, recalibration may
be necessary.
 Allow your scale to acclimate to the room temperature for at least one hour
before use.
 Store your scale in a clean, dry location. Dust, dirt, and moisture can
accumulate on the weighing sensors and electronics causing inaccuracy or
malfunction.
 Avoid using you scale in close proximity to strong radio wave emitting
devices such as computers, cash registers, and cordless phones.
 Always weigh on a flat level surface, free from vibrations and drafts. The
corner of a room is usually the most stable.
 Gently apply all items to be weighed. Do not drop items onto the weighing
platform.
 Avoid dropping your scale. The warranty does not cover damage due to
rough treatment or overload.
1- SPECIFICATION
Capacity 100g
Readability 0.01g
Units g/oz/dwt/ozt/gn/ct
Key function ON/OFF, MODE, TARE
Auto off 30 seconds of inactivity
Display LCD display with blue backlight
Operation temperature 50-86F
Power 1 x CR2032 Battery
Dimensions 1.6" X 3.4"
2-Operation
1. Place the scale on a leveled surface & press “ON/OFF” key to turn on the scale or
power off.
2. Wait until the LCD display “0.00”, then press “MODE” key to choose the weighing
unit.
3. Place the item to be weighed on the surface and wait until the reading is stable.
3-TARE FUNCTION
1. Turn on scale as described above.
2. Place the “Tare item” on the platform.
3. Press [Tare] key to zero out the display and wait until [0.0] is displayed.
4. Place items you want to weigh on the scale.
4-CALIBRATION
1. When the scale is turned off, press ON/OFF key to turn on the scale, until
zero is displayed.
2. Press and hold the MODE key, until the required weight flashes on the
display.
3. Place the required weight onto the center of the platform.
4. The LCD display reads “PASS” and come back to the normal weighing mode.
5-WARNINGS
1- “LO”: Low voltage. Please replace the batteries.
2- “O-ld” :Overload. Please remove item quickly to protect the scale.
6-OPERATING ENVIRONMENT
The optimum operating temperature for the scale is 50-86 F/10-30’C. Rough handling
of the scale will damage the internal sensor; so you must avoid actions such as
shaking or dropping the scale. This is sensitive electronic equipment and will be
affected by things such as moisture, extreme temperature changes, magnetic fields,
careless handling and misuse.
6-AUTOMATIC SHUT-OFF
The scale will automatically shut-off after 30 seconds of inactivity this is to help
conserve the battery power. We recommend good quality AAA batteries.
Tested to comply with FCC standards