US Balance US-MAJESTIC 100g x 0.01g - Manual

US-MAJESTIC - User Manual
Capacity: 100g x 0.01g - Weighing modes: g, oz, dwt, ozt, gn, ct
Thank you for purchasing US-MAJESTIC digital scale. Please read all
operation instructions carefully before use.
Scales are precision instruments and should always be handled with proper
care. To ensure years of reliable service, keep these simple tips in mind:
 Do not exceed the scales maximum capacity. Overloading your scale can
permanently damage it!
 Avoid exposure to extreme heat or cold. Scales perform best at normal room
temperature. If temperatures have changed dramatically, recalibration may
be necessary.
 Allow your scale to acclimate to the room temperature for at least one hour
before use.
 Store your scale in a clean, dry location. Dust, dirt, and moisture can
accumulate on the weighing sensors and electronics causing inaccuracy or
malfunction.
 Avoid using you scale in close proximity to strong radio wave emitting
devices such as computers, cash registers, and cordless phones.
 Always weigh on a flat level surface, free from vibrations and drafts. The
corner of a room is usually the most stable.
 Gently apply all items to be weighed. Do not drop items onto the weighing
platform.
 Avoid dropping your scale. The warranty does not cover damage due to
rough treatment or overload.
I- SPECIFICATION
Capacity 100g/3.52oz /64.30dwt/3.21ozt/ 1 543.23gn/
500ct
Readability 0.01g/0.00035oz/0.0064dwt/0.0003ozt/
0.154gn/0.05 ct
Units g/oz/dwt/ozt/ gn/ ct
Key Function ON/OFF, MODE, TARE
Auto off 180 seconds of inactivity
Operation temperature 50-86F
Power 2 x AAA Batteries (Included)
Dimensions 4.3" x 3.3" x 0.8"
Weight 150g
II- SCALE OPERATION
Place the Scale on a horizontal flat surface.
1. Press [ON/OFF] key.
2. Wait until [0.00] is displayed.
3. Put the object(s) on the weighing platform.
4. Using the [MODE] key, you can switch among the weighing units.
III-TARE Function
1. Turn on scale as described above.
2. Place the “tare Item” on the platform.
3. Press “TARE” key and wait until [0.00] is displayed.
4. Place the item to be weighed on the surface and wait until the reading is
stable.
VI- CALIBRATION
1. When the scale is turned off, press [ON/OFF] key to turn on the scale and waint
until [0.0] is displayed.
2. Press and hold the “MODE” key, until the display read [CAL] and then [100.00] will
flash on the LCD display.
3. Place a 100g weight on the center of the platform.
4. The LCD display reads [PASS] and then [100.00].
5. Remove the weight and press [ON/OFF] to turn off the scale. Finish!
V-TROUBLESHOOTING
The primary reasons for inaccuracy or malfunction are low batteries, incorrect
calibration, overload or operating on an unstable surface. Please keep this in mind
and maintain and operate your scale properly. The scale is a precise instrument and
must be handled with the utmost care and caution.
Display Elimination of errors
[LO] : Low battery, please replace the batteries.
[O-Ld] : You are overloading the scale. Remove the excessive load immediately!
Tested to comply with FCC standards