US Balance US-RUSH 200g x 0.01g - Manual

US-RUSH - User Manual
Capacity: 200g x 0.01g - Weighing modes: g, dwt, gn, ct
Thank you for purchasing US-RUSH digital scale. Please read all operation
instructions carefully before use.
Scales are precision instruments and should always be handled with proper
care. To ensure years of reliable service, keep these simple tips in mind:
 Do not exceed the scales maximum capacity. Overloading your scale can
permanently damage it!
 Avoid exposure to extreme heat or cold. Scales perform best at normal room
temperature. If temperatures have changed dramatically, recalibration may
be necessary.
 Allow your scale to acclimate to the room temperature for at least one hour
before use.
 Store your scale in a clean, dry location. Dust, dirt, and moisture can
accumulate on the weighing sensors and electronics causing inaccuracy or
malfunction.
 Avoid using you scale in close proximity to strong radio wave emitting
devices such as computers, cash registers, and cordless phones.
 Always weigh on a flat level surface, free from vibrations and drafts. The
corner of a room is usually the most stable.
 Gently apply all items to be weighed. Do not drop items onto the weighing
platform.
 Avoid dropping your scale. The warranty does not cover damage due to
rough treatment or overload.
1- Operation Instructions:
1. Place the scale on a leveled surface & power it on.
2. Press MODE key to select weighing mode, press K key to select purity.
3. Press M key, the purity symbol will flash now you can enter the price by
number keys. If you entered a wrong price, press DEL to clear it. Press M
key to store the price.
4. Press the K button to switch between gold purities.
2- SPECIFICATION
Capacity 200g
Readability 0.01g
Units g/gn/dwt/ct
Tare range Tare full capacity
Auto off 60 seconds
Operation temperature 50-86F
Power 2 x AAA Batteries (Included)
Dimensions 6.5” x 4.8” x 0.8”
Key function ON/OFF : turn the scale On and off
MODE : Change the weighing unit
TARE : Zero the scale
CAL : Calibration
NUMBERS : 0-9
M : Price input and memory
K : Selection gold purity
DEL : Clearing price from memory
Display LCD Display with blue backlight
3-TARE FUNCTION
1. Turn on scale as described above.
2. Place the “Tare item” on the platform.
3. Press [TARE] button to zero out the display, and wait until [0.0] is displayed.
4. Place items you want to weigh on the scale.
Once you finished weighing, remove all objects from the scale; press the
[TARE] again to cancel the TARE FUNCTION.
4-CALIBRATION
1. Place the scale on a flat / leveled surface & power it on.
2. Press the “CAL key once, the display reads “CAL”
3. Press the “CAL” key again and the display will show the required calibration
Weight “200g”
4. Place the weight on the center of the platform. The LCD display will read
“PASS” and then return to normal weighing mode.
5-Warning
1. “Lo” : Low voltage. Please replace the batteries.
2. “O-Ld” : Over Load. Please remove item quickly to protect the scale.
Tested to comply with FCC standards