Assembly – Ryobi RT102 User Manual
Page 10
10
Fig. 5
aSSeMBLY
Fig. 3
WarNING:
The router table should never be connected to a power
supply when you are assembling parts, making adjust-
ments, installing or removing cutters, cleaning, or when
not in use. Disconnecting the router table will prevent
accidental starting that could cause serious personal
injury.
aSSeMBLING tHe rOUter taBLe
Assembling the router table involves attaching the legs, the
under table guard, the switch box, the fence assembly, and
installing the miter gauge to the router table.
attaCHING tHe
LeGS
See Figure 3.
Place router table upside down on a flat, level surface
with the front edge closest to you.
Place each leg in a corner of the table.
NOte: Two of the legs have been keyed for proper
placement. With the table surface upside down, place the
leg with six holes in the front left corner of the table and
the leg with five holes in the front right corner of the table
to align with the tabs in the table. This will ensure proper
orientation of warning labels and switch. The remaining
two legs with four holes each attach to the rear of the
table.
Align the four holes in the legs with the four corresponding
threaded holes in the table.
Use the hex key to secure each leg with four socket head
screws and lock washers and 6 mm flat washers.
attaCHING tHe SWItCH BOX
See Figure 4.
Place the router table upside down on a flat surface.
Hold the switch box so that the words
ON and OFF on
the toggle switch are upside down.
Insert the switch box through the cutout in the left front
leg.
Align the two small holes in the mounting tabs with the
two small holes in the leg.
Use a screwdriver to secure the switch box with two pan
head screws and two 4 mm flat washers.
Fig. 4
SWITCH
BoX
CUToUT
PAN HEAD
SCREW
SWITCH /
SWITCH
KEY
UNDER
TABLE
GUARD
FLAT
WASHER
(6
mm)
SoCKET HEAD
SCREW
TABLE LEG
LoCK
WASHER
SoCKET HEAD SCREW
FLAT
WASHER
(6
mm)
FLAT WASHER
(4
mm)
MoUNTING
TAB
FRoNT SIDE
LEFT SIDE
RIGHT SIDE