Features – Ryobi RT102 User Manual
Page 8

8
FeatUreS
prODUCt SpeCIFICatIONS
Table Dimensions ...........................................13 in. x 18 in.
Maximum Cutter Diameter .................................1-15/16 in.
Fence Length.............................................................. 18 in.
Fig. 1
VACUUM
ATTACHMENT
MITER
GAUGE
SWITCH
FENCE
ASSEMBLY
SWITCH KEY
KNOW
YOUr rOUter taBLe
See Figure 1.
The safe use of this product requires an understanding of
the information on the product and in this operator’s manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all
operating features and safety rules.
CUtter GUarD
The cutter guard on the fence assembly provides a barrier
to protect the operator from contact with the cutter and is
designed to stay in contact with the workpiece.
FeNCe aSSeMBLY
The fence assembly provides an adjustable surface to sup-
port and guide the work. Molded into the fence assembly
is the vacuum attachment.
MIter GaUGe
A miter gauge is used for mitered routing and to help support
wider pieces.
Miter Slot .........................................3/8 in. x 5/8 in. x 18 in.
Rating ................................................10 V, AC only, 60 Hz
Net Weight ................................................................ 16 lbs.
StartING pIN
When you are unable to use the fence for a guide because
the workpiece is odd-shaped or too small, use the starting
pin for a guide. Only use piloted cutters when using the
starting pin.
SWItCH/SWItCH KeY
The router table has a conveniently located toggle switch. In
addition, the router table is equipped with a switch key. You
must insert the key to turn the switch on. If you remove the
key during operation, you can turn the switch off, but you
may not turn it on again until you replace the key.
tHrOat pLateS
Five throat plates are included with the router table. The
throat plate provides a stable surface around the cutter and
prevents objects from falling through the throat and damag-
ing the spindle.
VaCUUM attaCHMeNt
The dust ports molded into the fence will accept either a
1-1/4 in. or -1/ in. vacuum attachment.
CUTTER GUARD
THRoAT PLATES
STARTING
PIN