See also – Citizen Systems PPU-231II User Manual
Page 14
— 12 —
(3) Status caused by an error (when n = 3 is specified)
Bit
Status
Hex.
Decimal
0
Unused
00
0
1
Unused
02
2
2
No Black mark detection error occurred
(only when “Black mark” is selected).
00
0
A Black mark detection error occurred
(only when “Black mark” is selected).
04
4
3
Auto cutter error not occurred
00
0
Auto cutter error occurred
08
8
4
Unused
10
16
5
Unrecoverable error not occurred
00
0
Unrecoverable error occurred
20
32
6
Auto recovery error not occurred
00
0
Auto recovery error occurred
40
64
7
Undefined
00
0
Bit 3: If this error occurred because of a paper jam, for example,
remove the cause of the error, and then DLE ENQ n (1
n
2) can be used to recover from the error. However, it
is not possible to recover from any error due to a circuit
problem (e.g., broken wire).
Bit 6: If a head overheat error is detected, the printing is stopped
until the head temperature falls. At this time, bit 6 = “1”.
(4) Continuous paper detector status (When n = 4 is specified)
Bit
Status
Hex.
Decimal
0
Unused
00
0
1
Unused
02
02
2
Paper found by Paper Near-end Sensor 1
00
0
Paper not found by Paper Near-end Sensor 1
04
4
3
Paper found by Paper Near-end Sensor 2
00
0
Paper not found by Paper Near-end Sensor 2
08
8
4
Unused
10
16
5
Paper found by Paper-end Sensor
00
0
Paper not found by Paper-end Sensor
20
32
6
Paper found by Presenter Sensor
00
0
Paper not found by Presenter Sensor
40
64
7
Unused
00
0
[See Also]
DLE ENQ, GS a, GS r