Bradford White M-I-MH40T6FLX - Manual (Page 4)

4
GENERAL INFORMATION
This gas-fired water heater is design certified by the CSA International under the
applicable American National Standard, Z21.10.1 or Z21.10.3-(as indicated on the
rating plate) and CSA 4.1-(as indicated on the rating plate).
This water heater must be installed in accordance with local codes. In the absence of
local codes, it must be installed in compliance with the National Fuel Gas Code (ANSI
Z223.1-Latest Edition), or in Canada CAN/CGA B149.1 Natural Gas Installation Code
(Latest Edition) or CAN/CGA B149.2 Propane Installation Code (Latest Edition). The
warranty for this water heater is in effect only when the water heater is installed,
adjusted, and operated in accordance with these Installation and Operating
Instructions. The manufacturer will not be liable for any damage resulting from
alteration and/or failure to comply with these instructions. This water heater must be
installed in accordance with The Federal Manufactured Home Construction And Safety
Standard Title 24 CRF. part 3280 or CAN/CSA Z240 MH series, mobile home. This
water heater is designed certified for installation in a manufactured home (mobile
home) only and must be installed in an enclosure that will completely separate the
water heater combustion and venting systems from its interior. The water heater
enclosure access door must be on the outside wall of the manufactured home (mobile
home) only. Access to the water heater enclosure from the inside of the manufactured
home (mobile home) is not permitted.
CSA International has tested a representative sample of this water heater design for its
safety of operation. The CSA listing of this water heater includes the field installation of
the following components: roof jack and heater tie down materials. These components
for field installation may have been shipped with this heater and must be installed
according to these instructions. No other components are approved for use with this
water heater.
This water heater has been designed and certified for the purpose of heating potable
water. The installation and use of this water heater for any purpose other than the
heating of potable water may cause damage to the water heater, create a hazardous
condition, and nullify the warranty.
Do not use this appliance if any part has been submerged in water. You should contact
the plumbing professional who installed the water heater to inspect the appliance and to
replace any part of the control system including the combination gas control which has
been submerged in water.
CAUTION
Incorrect operation of this appliance may create a hazard to life and property
and will nullify the warranty.
DANGER
Do not store or use gasoline or other flammable, combustible, or corrosive
vapors and liquids in the vicinity of this or any other appliance.