B&C Technologies SP Series Commercial - Manual (Page 56)

Figure 6.1: Proper Pulley Alignment
Figure 6.2: Belt Tensioning Bolt
1. Tighten door hinges and fasteners, if necessary.
2. Tighten anchor bolts, if necessary.
3. Check all painted surfaces for bare metal (matching paint is available from the manufacturer.)
(a) If bare metal is showing, paint with primer or solvent-based paint.
(b) If rust appears, remove it with sand paper or chemical means. Then paint with primer
or solvent-based paint.
4. Clean steam filter, where applicable. See figure 6.3.
5. Remove back panel and check overflow hose and drain hose for leaks.
6. Remove top cover and check the supply dispenser hoses and hose connections.
7. Clean inlet hose filter screen:
(a) Turn water off and allow valve to cool, if necessary.
52