Wash program execution, End step condition: level, 3 wash program execution – B&C Technologies SP Series Commercial User Manual
Page 47: 1 end step condition: level

Dry Weight Capacity
Model
Capacity
SP-40
40 lbs
18 kg
SP-45
45 lbs
21 kg
SP-50
50 lbs
23 kg
SP-60
60 lbs
27 kg
SP-65
65 lbs
30 kg
SP-100
100 lbs
45 kg
SP-110
110 lsb
50 kg
SP-130
130 lbs
59 kg
SP-135
135 lbs
61 kg
SP-155
155 lbs
71 kg
SP-165
165 lbs
75 kg
SP-185
185 lbs
84 kg
SP-195
195 lbs
89 kg
Table 5.1: Proper Load Sizing
5.3
Wash Program Execution
After power is applied to the machine, and the internal diagnostics are complete, the machine is
ready for a program to be chosen. The EL6 display will show:
PROGRAM N.
The FM7 display will show:
ENTER PROG
Using the keypad, type the number of the program you wish to run followed by the ENTER key.
Standard programs are outlined in the EL6 stock program list, included with the machine. The
display will change to show the fist cycle of the selected program:
PRWH1 EXECUT.?
press START to execute the program, or RESET to return to program selection. While the program
is executing, the display shows the current segment of the program, and the ending condition of
the segment. See the following examples:
5.3.1
End Step Condition: Level
If the end requirement of the segment (step) is a particular water level, the display will show:
RINSE1 LVL=cm12
cm12 is the actual water level in the machine (12 centimeters). Pressing the LEVEL key shows, for
43