B&C Technologies SP Series Commercial - Manual (Page 49)

5.3.5 Partial Program
A program can be started from the beginning, or at any subsequent cycle. After selecting the
program you wish to execute, the display will show:
PRWH1 EXECUT.?
Instead of pressing START to execute the program, press the ADVANCE key. The cycles within
the program will be displayed incrementally. Choose the point at which you would like to begin,
and press the START key. The machine will begin operation from this point.
5.3.6 Displaying the Current Program and Step
While the machine is in operation, pressing then ENTER key will cause the display to show the
current program number and step.
PRG 1 STP 3
5.3.7 Soak
You can insert a pause at any point of the wash program with the exception of distribution and
spin. To do so, simply press the PAUSE key. The display will begin showing a time, counting up as
long as the machine remains paused. Pressing the START key will restart the program at the point
it was paused. As long as the machine is paused, all other WDT (watch dog timers) are paused as
well.
5.3.8 Advance
While any program is running, you can end the current step and advance to the next one by
pressing the ADVAN key. If the key is pressed during a spin, the spin will be aborted, and the
standard spin slow down time will be activated. It is possible to disable the advance function.
5.3.9 Halting a Program
At any time during the execution of the wash program, the running program can be terminated
by pressing the STOP key.
5.3.10 Water Level Refresh
While a program is running, if the water level drops to a level which is 3cm below the target level,
cold water will automatically be added to replenish the level.
45