Allen Sports XLT2 - Manual (Page 3)

INSTRUCTIONAL
OWNER’S MANUAL
3
TRAILER ASSEMBLY & OPERATING INSTRUCTIONS
STEP 1:
STEP 2:
WARNING!: IMMEDIATELY DISCARD ALL PLASTIC BAGS AND WHEEL
WRAPPING MATERIALS!
WARNING!: You must make certain the frame is locked before using the trailer. Failure to do so could result in
serious injury to you or your child.
Remove the trailer, wheels, hitch arm and walking kit from the box.
OPEN FRAME
A. Remove trailer and all components from carton. Unfold trailer by pulling the frame and remove all
components from inside (Fig. 2a).
B. Lift both side panels into an upright position (Fig 2b). Lift the crossbar with seatback attached, and
slide the connector located on the crossbar into the slot in the locking mechanism on the window panel
as show (Fig 2b). Make sure both sides are locked in place. When locking, you will hear an audible “click”
to indicate the mechanism is engaged. After assembly, attempt to pull the crossbar out by tugging on the
bar – it should not come out
C.To remove the crossbar for folding, press the red release button while pulling the crossbar up and away
from the frame (Fig 2c).
FIGURE 2a FIGURE 2b.
FIGURE 1
FIGURE 2c
Your xlt2 trailer uses simple and convenient push button quick-release wheels.
STEP 1:
STEP 2:
STEP 3:
STEP 4:
Push the button on the outside of the wheel hub.
Insert the axle through the hanger bracket on the frame as shown (fig 3).
Push all the way in and release the pushbutton. The wheel is automatically
locked in place.
Give each wheel a tug to make sure they are secure.
WHEEL INSTALLATION
FIGURE 3
NOTE: 1. Set the jogger kid aside, as you will install this later.
2. Lay the trailer on the ground with the black fabric
side down.