Allen Sports XLT2 - Manual (Page 13)

INSTRUCTIONAL
OWNER’S MANUAL
13
STEP 1:
STEP 2:
STEP 1:
STEP 2:
Open the quick release axle skewer to allow the axle to fit inside the plastic fork tips. Align the
flats on the axle with the flats on the fork tips, and slide into the slots.T
Close the QR lever, making sure it is tight. If the wheel Is still loose in the frame, open the re-
lease lever, tighten the thumb nut, and close the lever again. Repeat this until there is sufficient
resistance to securely lock the wheel.
Take the small tubes with hardware, and using bolts and nuts
provided, assemble to the holes in the rear of the frame.
Using the spanner and hex wrench included, tighten securely
as shown.
insert handlebar in the small tubes you have just installed on the frame. Depress the spring pins
and allow the handlebar to slide in to the small tubes until they lock in place.
NOTE: Make sure the long portion of the handlebar fixing tube is up,
as shown.
NOTE: When using the trailer as a jogger, make sure to use the safety wrist strap shown above.
INSTALL WHEEL
INSTALL HANDLEBAR
NOTE: If the wheel does not track straight, loosen the lever and shift the wheel in the slot to adjust the direction,
and retighten.