Allen Sports XLT-X2 - Manual (Page 6)

INSTRUCTIONAL
OWNER’S MANUAL
6
FIVE-POINT HARNESS
SAFETY WRIST STRAP
STEP 2:
STEP 2:
STEP 3:
STEP 4:
STEP 5:
NOTE:
NOTE:
STEP 1:
STEP 1:
Adjust the upper buckles to fit snugly above your child’s shoulders. The crotch strap buckle should come just
below your child’s belly button, where a normal belt could lay.
Place large loop over your hand, coming to rest on your wrist. Simply
remove when not using the stroller. (Fig. A)
Unclip the straps and place your children in the seat.
Make sure saftey wrist strap is secured to the bottom of the rear axle of your
stroller. To secure the strap lace the larger looped end through the samller
end and tighten around botto rear axle.
Adjust the ladder lock so the buckle is in the correct position.
Buckle the two side straps to the crotch strap and adjust snugly so you can fit average size fingers between
belt and your child.
The buckle should be centered in your child’s abdomen. Hook the shoulder straps to the D-rings on the
buckle and adjust the ladder locks so they fit snugly.
Place a single child in the center and use the center strap in the middle. For two children use the outer
center straps and shoulder straps.
The model XLT-X2 includes a safety wrist strap that should be installed and
used whenever the XLT-X2 in the jogger/ stroller mode. Always use the wrist
strap when a passenger is in the stroller.
WARNING!: To avoid serious injury or death, children should always wear the seat belt and shoulder straps and helmet.
WARNING!: Never leave passenger unattended and use wrist strap anytime a passenger is in the stroller.
WARNING!: Always remove the wrist strap when using the XLT-X2 in trailer mode.
Wrist Strap
FIGURE A