Allen Sports XLT-X2 - Manual (Page 3)

INSTRUCTIONAL
OWNER’S MANUAL
3
MAIN CABIN FRAME AND ASSEMBLY
STEP 1:
STEP 2:
STEP 3:
STEP 4:
WARNING!: You must make certain the frame is locked before using the trailer. Failure to do so could result in
serious injury to you or your child. Make sure the secondary paddle latch is engaged prior to use. Both
latches are necessary for safe operation.
Remove the trailer, wheels, hitch arm and walking kit from the box.
Finally, close the black paddle latch in the center of the handlebar assembly to lock the frame in place (Fig 6).
FIGURE 1.
FIGURE 4.
FIGURE 2.
FIGURE 5.
FIGURE A
FIGURE 3.
FIGURE 6.
NOTE: 1. Set the walking kit small swivel wheel aside, as you will
install this later.
2. Lay the trailer on the ground with the black fabric
side down.
To open frame, first, lift front cabin tube up, and then lift rear cabin tube (Fig 2), allowing the rear cabin
tube to meet and rest in the plastic cradle of the front tube, (Fig 3, 4).
Next, lift the handlebar, rotating it toward the back of the trailer, and press down until the latches engage (Fig 5).