Allen Sports XLT-X2 - Manual (Page 10)

INSTRUCTIONAL
OWNER’S MANUAL
10
STEP 4:
STEP 5:
STEP 6:
STEP 7:
Place the Wheel Guard/Brake Assembly against the frame, and use the hex key wrench provided to
tighten the screws until snug.
To operate brake, simply move lever outward to contact tire, release by pushing the lever in toward frame.
The nut is secured inside the plastic housing so you will not need a wrench or plier to hold the nut
while tightening the fixing screw.
This brake is self-adjusting to tire wear, but for best function, make sure to keep tires within rated
pressure on sidewall, and replace tires when you notice visible signs of wear.
Figure 22 shows the brake mechanism operation on the trailer,pulling the lever out from the frame.
Fig23 shows the brake mechanism in locked position. For safety, lock both brakes to prevent rolling,
and make certain both brakes are released prior to riding.
NOTE:
NOTE:
FIGURE 22 FIGURE 23
PARKING BRAKE (CONT.)