beautypg.com

Cabletron Systems 9A100 User Manual

Page 93

background image

SmartSwitch 9A100 User Guide B-7

Agent Support

Managing the SmartSwitch 9A100

Not Supported

The following MIB objects are not supported. If used, these objects return either the value zero or the message, “Not
supported.”

atmInterfaceMaxVpcs

atmInterfaceConfVpcs

atmInterfaceDs3PlcpTable

atmInterfaceTCTable

atmVplTable

atmVpCrossConnectIndexNext

atmVpCrossConnectTable

atmSvcVpCrossConnectTable

atmSigSupportTable

atmSigDescrParamTable

atmIfAdminAddrTable

atmVclAddrBindTable

atmAddrVclTable

atmVplStatTable

atmVplLogicalPortTable

atmVclGenTable

atmfMyOsiNmNsapAddress

atmfVpcTable

lecRouteDescrTable

leRDArpTable

B.2

MANAGING THE SmartSwitch 9A100

Your SmartSwitch 9A100 must be IP reachable by the network management system (NMS) before it can be managed.
The default connection between the SmartSwitch 9A100 and the NMS is the SmartSwitch 9A100 Ethernet interface.
Use the

show SwitchConfig

command to find the IP address of the SmartSwitch 9A100. An NMS can use this IP

address to reach the SmartSwitch 9A100 through Ethernet. An NMS can also manage the SmartSwitch 9A100
through one of its ATM ports if the SmartSwitch 9A100 has a client connection into a VLAN or emulated LAN.

Note that the SmartSwitch 9A100 itself, is not reachable through ATM until a client for the switch is created and
participates as a member of a VLAN or ELAN. Your NMS uses that switch client’s address to access and manage the
switch.

To create a client for the switch, use the

add IPATMClient

command for VLANs and

add LANEClient

for emulated

LANs.

Use the

set MyNmAddr

command to tell the SmartSwitch 9A100 which interface to use when communicating with your

NMS. For detailed information about these commands, see the SmartCell 6A000/ZX-250 Reference Manual.