Cabletron Systems 9A100 - Manual (Page 25)

SmartSwitch 9A100 User Guide 2-7
Switch Installation and Setup Configuring the Switch
Figure 2-3 SmartSwitch 9A100 console and network connections
–• Start the dumb terminal or PC and its terminal emulation software.
•• When power is applied to the SmartSwitch 9A100, the module emits a series of diagnostic messages.
If you inserted the module into a chassis that was turned off, turn it on now; the diagnostics will
appear after a 6-second delay. If you inserted the module into a chassis that was turned on, press the
Reset switch to see the diagnostics.
G• After the diagnostics are finished, the switch prompts for a password. Enter the default password,
"admin."
Terminal
Ethernet
Hub
Terminal
RJ-45
Port
Ethernet
RJ-45
Port