Cabletron Systems 9A100 - Manual (Page 92)

B-6 SmartSwitch 9A100 User Guide
MIB, SMI, MIB Files and Internet MIB Hierarchy Agent Support
B.1.6 SmartSwitch 9A100 MIB Support
The SmartSwitch 9A100 is shipped with the following MIBs:
• MIB II (RFC 1213)
• Interface Table MIB (RFC 1573)
• AToM MIB (RFC 1695)
• AToM2 MIB (pre-standard)
• LANE MIB (ATM Forum)
• ILMI 4.0 MIB (ATM Forum)
• IP over ATM MIB (pre-standard)
• SmartSwitch 9A100 Switch MIBs (proprietary)
Note Along with the MIBs, the diskette also contains a README file and the release
note.
B.1.7 MIB Exceptions
With the current implementation of MIB files, conformance to ATM standards for the SmartSwitch 9A100 ATM
switch includes the following exceptions.
Non-Conformance
• atmInterfaceIlmiVpi — Read-only
• atmInterfaceIlmiVci — Read-only
• aal5VccTable — Not supported
• atmSvcVcCrossConnectRowStatus Set — Not supported
• atmConfigSigType — The values given below are not supported:
- ituDss2
- atmfBici2Dot0
• znIpAtmClientDDVcType — Accepts only pvc(2) in sets
• lecMulticastSendType — Accepts only best effort (1)
• lecMulticastSendAvgRate — Accepts values only up to 370370
• lecMulticastSendPeakRate — Accepts values only up to 370370
• leArpEntryType — Accepts only staticVolatile (4) and staticNonVolatile (5)
• lesControlTimeout — Read-only