Workrite SwingArm–Dual - Manual (Page 7)

Workrite Ergonomics, Inc 7
SwingArm–Dual™ Installation Instructions
Step 2: Attach Monitor Arms to Monitors
Place monitor carefully on a clean, flat surface, face down. A:
Attach the monitor arm (IV-1) to the back of the monitor with four screws, using a Phillips- B:
head screwdriver (not included). Use the mounting screws provided by your monitor manu-
facturer if available. Otherwise, use the screws provided that best fits your monitor (IV-4 or
IV-5).
If the mounting area on your monitor is smaller than the 100mm VESA connecting plate
and is recessed, remove the plate and replace it with the smaller 75mm plate (IV-6). Then
attach the plate to the back of the monitor.
Repeat A & B for the second monitor. C: