Workrite SwingArm–Dual - Manual (Page 6)

6 Workrite Ergonomics, Inc
SwingArm–Dual™ Installation Instructions
Step 1: Attach Clamp Base to Work
Surface
(If you are using the grommet base, please skip to
Step 1x.)
Attach the base cushion (I-3) to the un- A:
derside of the base (I-1).
Attach 14” pole (II-1) to base, securely B:
tighten 4 set screws (already in place).
If there is not enough clearance to fit the C:
assembled base between the back of the
work surface and the wall, place the clamp
base on the desk edge before attaching
Step 1x: Attach Grommet Base to Work
Surface
Remove the center hole from the base A:
cushion (Ix-6), then attach it to the under-
side of the base (Ix-1), aligning the hole
in the base with the hole in the protector.
Thread the M8 Thread Rod (Ix-3) into the
bottom of the base.
Attach 14” pole (II-1) to base, securely B:
tighten 4 set screws (already in place).
A
D
C
B
D
A
B
C
Place the base on the C:
work surface, centering it
over a bolting hole from
3/8” to 3” in diameter.
Position the U-Bracket D:
(Ix-2) and Small Wash-
er (Ix-4) onto the M8
Thread Rod and secure
the bracket by tightening
the Wing Nut (Ix-5).
Proceed to step 2. E:
the clamping bracket (I-2)
from below. Otherwise, at-
tach the clamping bracket
with 2 button-head cap
screws (I-6) before placing
the base on the work sur-
face.
Use the upper set of holes
on the bracket for work sur-
faces between ½” and 1¼”
thick, and use the lower set
for work surfaces between
1¼” and 2¼” thick.
Tighten the clamping bracket D:
until it is firmly clamped to
the work surface.
Skip to step 2. E: